DA-Y20 | Measurement Distance Sensor | DADISICK

contact supplier

Paramtents

Packging & Delivery

Briefing

Measuring frequency: 1Hz-40Hz
Communication interface: RS232/RS485 (switchable)
Measuring distance: 0.2-20m
Measurement resolution: 1mm

Detailed

DADISICK Measurement Distance Sensor

DA-Y & DB-Y Series

Models comparison
Type A
Models	DA-Y10	DA-Y20	DA-Y30	DA-Y50	DA-Y100
Measuring range	0.2-10m	0.2-20m	0.2-30m	0.2-50m	0.2-100m
Output mode	Digital quantity & switch quantity
Type B
Models	DB-Y10	DB-Y20	DB-Y30	DB-Y50	DB-Y100
Measuring range	0.2-10m	0.2-20m	0.2-30m	0.2-50m	0.2-100m
Voltage/current output	Can be set to 0~5V / 0~10V / 4~20mA / 0~20mA /0~24mA output *Note 2
Voltage output error	0.2%+0.5mV
Current output error	0.2%+0.005mA
Output mode	Digital quantity, switch quantity, analog quantity

Specification
Communication interface		RS232/RS485 (switchable)
Measuring frequency		1Hz-40Hz
Laser type		Class II, 660±15nm, ≤1mW
Measurement resolution		1mm
Measurement error		±(2mm+d * one ten thousandth) *Note 1
Indicator light		Red laser
Spot size		@1m∅6mm; @10m∅8mm; @20m∅12mm; @30m∅16mm;
Display		128x32 dot matrix screen
Backlight off time		30 minutes (can be set to normally on)
Operating mode		Off measurement, continuous measurement
Transistor switch output		2 channels (cannot exceed DC36V 0.5A) *Note 3
Power supply		DC15~30V
Power consumption		＜3.0W
Protection grade		IP67
Shell material		Die-cast zinc alloy
Working temperature		-10°C~50°C
Storage temperature and humidity		-20°C~60°C, 20%~85%RH
Overheating protection		When the body temperature is higher than 70°C, the measurement will be shut down and when the temperature is lower than 70°C, the measurement will be resumed.
Dimension		88.45x40x59.3mm (including connection base)
Notes		Note 1: When [Speed Level] is 1. "d" represents the actual distance. In harsh environments, such as when the sun is too strong and the ambient temperature fluctuates too much, there will be a large error in the measurement results. In this case, the effect is better when used with a target reflector. Note 2: Current and voltage can' t be output at the same time. *Note 3: If the external DC output of the transistor switch exceeds the limited voltage or current, it may cause permanent damage to the instrument.

DIMENSION

WIRING DIAGRAM

RS485 Wiring Method

RS232 Wiring Method

DOCUMENTS & DOWNLOADS

CATALOGUE

DA-Y&DB-Y series laser displacement sensor

DA-Y&DB-Y series user's manual